PC (聚碳酸酯)
PC-T30 Makrolon® TC110_AG
Manufacturer：科思创德国公司
导热
Recorded properties
Record date：2026-11-07
| Property | Value | Unit |
|---|---|---|
| Density | 1.45 | g/cm³ |
| Melt flow rate | 9.0 | g/10min |
| Tensile strength | 55.0 | MPa |
| Tensile modulus | 6500.0 | MPa |
| Elongation at break | 3.0 | % |
| Flexural strength | 100.0 | MPa |
| Flexural modulus | 6500.0 | MPa |
| Vicat softening point | 145.0 | °C |
| Flame rating | {'GWFI': '875 °C', 'GWIT': '850 °C'} | — |
Test standard, specimen condition and source rights are not fully recorded. Values are for preliminary screening only; verify with the manufacturer before design or purchasing decisions.
Grade handling information to verify
The information below was automatically extracted from a material PDF and has not been individually reviewed. It is for preliminary reference only. Verify the exact grade’s manufacturer processing instructions, safety data sheet and equipment procedures before production; do not use candidate values directly as machine settings.
Matched by original PDF filename
- Storage
- Review the source for packaging, storage and opened-package instructions.
- Drying
- Candidate injection-molding recommendations: temperature 120 °C; time 4 h. Verify the source, grade and conditions.
- Equipment setup
- Candidate injection-molding recommendations: melt temperature 300 °C; mold temperature 90 °C. Verify the source, grade and conditions.
- Applications
- Candidate application areas in the source: electrical and electronics. Verify the source, exact use and applicable approvals.
Source: the matched material PDF; page numbers refer to the original PDF.
- Drying temperature：page 1
- Drying time：page 1
- Melt temperature：page 1
- Mold temperature：page 1
- Application areas：page 1
