PC

Makrolon® 2658 RE

Manufacturer:科思创德国公司

透明,不透明,可灭菌,环氧乙烷(EtO)

Recorded properties

Record date:2026-11-07

PropertyValueUnit
Density1.2g/cm³
Melt flow rate13.0g/10min
Tensile strength66.0MPa
Tensile modulus2400.0MPa
Elongation at break50.0%
Flexural strength97.0MPa
Flexural modulus2400.0MPa
Notched impact strength70.0kJ/m²
HDT 1.8MPa124.0°C
HDT 0.45MPa137.0°C
Vicat softening point144.0°C
Flame rating{'glow_wire_flammability_index_1_5_mm': 930, 'glow_wire_flammability_index_3_mm': 850, 'glow_wire_ignition_temperature_0_75_mm': 875, 'glow_wire_ignition_temperature_1_5_mm': 875, 'glow_wire_ignition_temperature_3_mm': 875, 'thickness_tested_0_75_mm': 1.5, 'thickness_tested_1_5_mm': 1.5, 'thickness_tested_3_mm': 3, 'burning_behavior': 'V-2', 'oxygen_index': 27}—

Test standard, specimen condition and source rights are not fully recorded. Values are for preliminary screening only; verify with the manufacturer before design or purchasing decisions.

Grade handling information to verify

The information below was automatically extracted from a material PDF and has not been individually reviewed. It is for preliminary reference only. Verify the exact grade’s manufacturer processing instructions, safety data sheet and equipment procedures before production; do not use candidate values directly as machine settings.

Matched by original PDF filename

Storage
Review the source for packaging, storage and opened-package instructions.
Drying
Candidate injection-molding recommendations: temperature 120 °C; time 4 h; processing moisture ≤0.02 %. Verify the source, grade and conditions.
Equipment setup
Candidate injection-molding recommendations: melt temperature 280 - 320 °C; mold temperature 70 - 110 °C. Verify the source, grade and conditions.
Applications
Candidate application areas in the source: medical. Verify the source, exact use and applicable approvals.

Source: the matched material PDF; page numbers refer to the original PDF.

  • Drying temperature:page 2
  • Drying time:page 2
  • Processing moisture:page 2
  • Melt temperature:page 2
  • Mold temperature:page 2
  • Application areas:page 3