Polyethylene High Density (PE-HD)
ML 71
Manufacturer：LITEN®
均聚物，紫外线稳定或耐候性
Recorded properties
Record date：2026-11-08
| Property | Value | Unit |
|---|---|---|
| Density | 0.963 | g/cm³ |
| Melt flow rate | 8.0 | g/10min |
| Tensile strength | 25.0 | MPa |
| Tensile modulus | 1250.0 | MPa |
| Elongation at break | 8.5 | % |
| Flexural modulus | 1100.0 | MPa |
| Notched impact strength | 6.5 | kJ/m² |
| HDT 1.8MPa | 45.0 | °C |
Test standard, specimen condition and source rights are not fully recorded. Values are for preliminary screening only; verify with the manufacturer before design or purchasing decisions.
Grade handling information to verify
The information below was automatically extracted from a material PDF and has not been individually reviewed. It is for preliminary reference only. Verify the exact grade’s manufacturer processing instructions, safety data sheet and equipment procedures before production; do not use candidate values directly as machine settings.
Matched by original PDF filename
- Storage
- Review the source for packaging, storage and opened-package instructions.
- Drying
- No drying value was confirmed by extraction; review the source.
- Equipment setup
- Candidate injection-molding recommendations: melt temperature 200 - 260 °C; mold temperature 20 - 60 °C. Verify the source, grade and conditions.
- Applications
- Review the source and applicable approvals.
Source: the matched material PDF; page numbers refer to the original PDF.
- Melt temperature：page 1
- Mold temperature：page 1
