Low Density Polyethylene (LDPE)
LDI300YY
Manufacturer：乐天化学 Titan (M) 沙登有限公司
高光泽
Recorded properties
Record date：2026-11-08
| Property | Value | Unit |
|---|---|---|
| Density | 0.92 | g/cm³ |
| Melt flow rate | 20.0 | g/10min |
| Tensile strength | 11.8 | MPa |
| Elongation at break | 120.0 | % |
| Vicat softening point | 87.0 | °C |
Test standard, specimen condition and source rights are not fully recorded. Values are for preliminary screening only; verify with the manufacturer before design or purchasing decisions.
Grade handling information to verify
The information below was automatically extracted from a material PDF and has not been individually reviewed. It is for preliminary reference only. Verify the exact grade’s manufacturer processing instructions, safety data sheet and equipment procedures before production; do not use candidate values directly as machine settings.
Matched by original PDF filename
- Storage
- Review the source for packaging, storage and opened-package instructions.
- Drying
- No drying value was confirmed by extraction; review the source.
- Equipment setup
- Candidate injection-molding recommendations: melt temperature 160 - 240 °C; mold temperature 15 - 50 °C. Verify the source, grade and conditions.
- Applications
- Candidate application areas in the source: packaging. Verify the source, exact use and applicable approvals.
Source: the matched material PDF; page numbers refer to the original PDF.
- Melt temperature：page 1
- Mold temperature：page 1
- Application areas：page 1
