Polyphenylene Ether (PPE) + Polyamide (PA)

NORYL GTX™ Resin GTX910C

Manufacturer:Not recorded

Recorded properties

Record date:2026-11-08

PropertyValueUnit
Density1.09g/cm³
Melt flow rate15.0g/10min
Tensile strength48.0MPa
Tensile modulus1992.0MPa
Elongation at break63.0%
Flexural strength67.0MPa
Flexural modulus1530.0MPa
Notched impact strength30.0kJ/m²
HDT 1.8MPa158.0°C
HDT 0.45MPa86.0°C
Vicat softening point172.0°C

Test standard, specimen condition and source rights are not fully recorded. Values are for preliminary screening only; verify with the manufacturer before design or purchasing decisions.

Grade handling information to verify

The information below was automatically extracted from a material PDF and has not been individually reviewed. It is for preliminary reference only. Verify the exact grade’s manufacturer processing instructions, safety data sheet and equipment procedures before production; do not use candidate values directly as machine settings.

Matched by original PDF filename

Storage
Review the source for packaging, storage and opened-package instructions.
Drying
Candidate injection-molding recommendations: temperature 120 °C; time 3 - 4 h; processing moisture ≤0.02 %. Verify the source, grade and conditions.
Equipment setup
Candidate injection-molding recommendations: melt temperature 280 - 305 °C; mold temperature 20 - 80 °C. Verify the source, grade and conditions.
Applications
Candidate application areas in the source: automotive. Verify the source, exact use and applicable approvals.

Source: the matched material PDF; page numbers refer to the original PDF.

  • Drying temperature:page 2
  • Drying time:page 2
  • Processing moisture:page 2
  • Melt temperature:page 2
  • Mold temperature:page 2
  • Application areas:page 2