Polyphenylene Ether (PPE) + Polyamide (PA)

GTX973

Manufacturer:NORYL GTX™

导电,非增强合金

Recorded properties

Record date:2026-11-08

PropertyValueUnit
Density0.945g/cm³
Melt flow rate20.0g/10min
Tensile strength60.0MPa
Tensile modulus2300.0MPa
Elongation at break30.0%
Flexural modulus2300.0MPa
Notched impact strength15.0kJ/m²
Vicat softening point195.0°C
Flame rating{'GWFI': '675 °C', 'GWIT': '675 °C', 'thickness_tested': '1.5 mm'}—

Test standard, specimen condition and source rights are not fully recorded. Values are for preliminary screening only; verify with the manufacturer before design or purchasing decisions.

Grade handling information to verify

The information below was automatically extracted from a material PDF and has not been individually reviewed. It is for preliminary reference only. Verify the exact grade’s manufacturer processing instructions, safety data sheet and equipment procedures before production; do not use candidate values directly as machine settings.

Matched by original PDF filename

Storage
Review the source for packaging, storage and opened-package instructions.
Drying
Candidate injection-molding recommendations: temperature 100 - 120 °C; time 2 - 3 h; processing moisture ≤0.07 %. Verify the source, grade and conditions.
Equipment setup
Candidate injection-molding recommendations: melt temperature 290 - 320 °C; mold temperature 100 - 120 °C. Verify the source, grade and conditions.
Applications
Candidate application areas in the source: automotive. Verify the source, exact use and applicable approvals.

Source: the matched material PDF; page numbers refer to the original PDF.

  • Drying temperature:page 2
  • Drying time:page 2
  • Processing moisture:page 2
  • Melt temperature:page 2
  • Mold temperature:page 2
  • Application areas:page 2