Polyphenylene Ether (PPE) + Crystal Clear Polystyrene (ccPS)
FE1740PW
Manufacturer：诺瑞尔
水解稳定性良好，符合FDA食品接触要求，NSF/ANSI 61*、ACS、WRAS、KTW和W270认证，适用于全球饮用水
Recorded properties
Record date：2026-11-08
| Property | Value | Unit |
|---|---|---|
| Density | 1.4 | g/cm³ |
| Melt flow rate | 10.0 | g/10min |
| Tensile strength | 165.0 | MPa |
| Tensile modulus | 13800.0 | MPa |
| Elongation at break | 1.8 | % |
| Flexural modulus | 11700.0 | MPa |
| Notched impact strength | 30.0 | kJ/m² |
| HDT 1.8MPa | 147.0 | °C |
| Vicat softening point | 152.0 | °C |
Test standard, specimen condition and source rights are not fully recorded. Values are for preliminary screening only; verify with the manufacturer before design or purchasing decisions.
Grade handling information to verify
The information below was automatically extracted from a material PDF and has not been individually reviewed. It is for preliminary reference only. Verify the exact grade’s manufacturer processing instructions, safety data sheet and equipment procedures before production; do not use candidate values directly as machine settings.
Matched by original PDF filename
- Storage
- Review the source for packaging, storage and opened-package instructions.
- Drying
- Candidate injection-molding recommendations: temperature 100 - 120 °C; time 2 - 4 h; processing moisture ≤0.02 %. Verify the source, grade and conditions.
- Equipment setup
- Candidate injection-molding recommendations: melt temperature 280 - 300 °C; mold temperature 80 - 120 °C. Verify the source, grade and conditions.
- Applications
- Review the source and applicable approvals.
Source: the matched material PDF; page numbers refer to the original PDF.
- Drying temperature：page 1
- Drying time：page 1
- Processing moisture：page 1
- Melt temperature：page 1
- Mold temperature：page 1
