PPE+PS

N850

Manufacturer:Not recorded

Recorded properties

Record date:2026-11-08

PropertyValueUnit
Density1.13g/cm³
Melt flow rate18.0g/10min
Tensile strength66.0MPa
Tensile modulus2950.0MPa
Elongation at break3.2%
Flexural modulus2600.0MPa
HDT 1.8MPa82.0°C
HDT 0.45MPa95.0°C
Vicat softening point108.0°C
Flame ratingUL94 flame rating of 5VA at 3mm and V0 at 1.5mm, UL746C Outdoor Suitability rating of F2—

Test standard, specimen condition and source rights are not fully recorded. Values are for preliminary screening only; verify with the manufacturer before design or purchasing decisions.

Grade handling information to verify

The information below was automatically extracted from a material PDF and has not been individually reviewed. It is for preliminary reference only. Verify the exact grade’s manufacturer processing instructions, safety data sheet and equipment procedures before production; do not use candidate values directly as machine settings.

Matched by original PDF filename

Storage
Review the source for packaging, storage and opened-package instructions.
Drying
Candidate injection-molding recommendations: temperature 75 - 80 °C; time 3 - 4 h; processing moisture ≤0.02 %. Verify the source, grade and conditions.
Equipment setup
Candidate injection-molding recommendations: melt temperature 250 - 275 °C; mold temperature 55 - 75 °C. Verify the source, grade and conditions.
Applications
Review the source and applicable approvals.

Source: the matched material PDF; page numbers refer to the original PDF.

  • Drying temperature:page 1
  • Drying time:page 1
  • Processing moisture:page 1
  • Melt temperature:page 1
  • Mold temperature:page 1