PPE+PS

N300X

Manufacturer:NORYL™

非增强型聚苯醚(PPE)+ 高冲击聚苯乙烯(HIPS)的混合物

Recorded properties

Record date:2026-11-08

PropertyValueUnit
Density1.1g/cm³
Melt flow rate7.4g/10min
Tensile strength75.0MPa
Tensile modulus2220.0MPa
Elongation at break13.0%
Flexural strength112.0MPa
Flexural modulus2520.0MPa
HDT 1.8MPa155.0°C
HDT 0.45MPa140.0°C
Vicat softening point162.0°C
Flame ratingUL94 flame rating of 5VA at 2mm and V0 at 1.5mm—

Test standard, specimen condition and source rights are not fully recorded. Values are for preliminary screening only; verify with the manufacturer before design or purchasing decisions.

Grade handling information to verify

The information below was automatically extracted from a material PDF and has not been individually reviewed. It is for preliminary reference only. Verify the exact grade’s manufacturer processing instructions, safety data sheet and equipment procedures before production; do not use candidate values directly as machine settings.

Matched by original PDF filename

Storage
Review the source for packaging, storage and opened-package instructions.
Drying
Candidate injection-molding recommendations: temperature 110 - 120 °C; time 3 - 4 h; processing moisture ≤0.02 %. Verify the source, grade and conditions.
Equipment setup
Candidate injection-molding recommendations: melt temperature 300 - 325 °C; mold temperature 80 - 110 °C. Verify the source, grade and conditions.
Applications
Review the source and applicable approvals.

Source: the matched material PDF; page numbers refer to the original PDF.

  • Drying temperature:page 2
  • Drying time:page 2
  • Processing moisture:page 2
  • Melt temperature:page 2
  • Mold temperature:page 2