Radel® R-5100 RD1018
Radel® R-5100 RD1018
Manufacturer:Not available in English
{'processing': 'Injection Molding, Film Extrusion, Profile Extrusion, Sheet Extrusion, Blow Molding, Thermoforming', 'special_characteristics': 'Flame retardant, Heat stabilized or stable to heat, Sterilizable, Ethylene Oxide (EtO) Sterilization, Steam sterili
Recorded properties
Record date:2026-11-08
| Property | Value | Unit |
|---|---|---|
| Density | 1.3 | g/cm³ |
| Melt flow rate | 17.0 | g/10min |
| Tensile strength | 69.6 | MPa |
| Tensile modulus | 2340.0 | MPa |
| Elongation at break | 60.0 | % |
| Flexural modulus | 2410.0 | MPa |
| Notched impact strength | 690.0 | kJ/m² |
| HDT 1.8MPa | 214.0 | °C |
| HDT 0.45MPa | 207.0 | °C |
| Flame rating | {'UL_94_Flame_rating': 'V-0', 'thickness_tested': '0.75 mm', 'test_standard': 'UL 94'} | — |
Test standard, specimen condition and source rights are not fully recorded. Values are for preliminary screening only; verify with the manufacturer before design or purchasing decisions.
Grade handling information to verify
The information below was automatically extracted from a material PDF and has not been individually reviewed. It is for preliminary reference only. Verify the exact grade’s manufacturer processing instructions, safety data sheet and equipment procedures before production; do not use candidate values directly as machine settings.
Matched by original PDF filename
- Storage
- Review the source for packaging, storage and opened-package instructions.
- Drying
- Candidate injection-molding recommendations: temperature 149 °C; time 2.5 h; processing moisture ≤0.05 %. Verify the source, grade and conditions.
- Equipment setup
- Candidate injection-molding recommendations: melt temperature 343 - 388 °C; mold temperature 138 - 163 °C. Verify the source, grade and conditions.
- Applications
- Candidate application areas in the source: medical. Verify the source, exact use and applicable approvals.
Source: the matched material PDF; page numbers refer to the original PDF.
- Drying temperature:page 1
- Drying time:page 1
- Processing moisture:page 1
- Melt temperature:page 1
- Mold temperature:page 1
- Application areas:page 2