Looking for a reliable supplier or an alternative grade? Tell us what you need

Thermoforce® EL PA6 N01000 Ungefärbt

Thermoforce® EL PA6 N01000 Ungefärbt

Manufacturer:Not available in English

Increased electrical conductivity, Thermally Conductive

Recorded properties

Record date:2026-11-07

PropertyValueUnit
Density1.53g/cm³
Tensile strength80.0MPa
Tensile modulus13700.0MPa
Elongation at break1.2%

Test standard, specimen condition and source rights are not fully recorded. Values are for preliminary screening only; verify with the manufacturer before design or purchasing decisions.

Grade handling information to verify

The information below was automatically extracted from a material PDF and has not been individually reviewed. It is for preliminary reference only. Verify the exact grade’s manufacturer processing instructions, safety data sheet and equipment procedures before production; do not use candidate values directly as machine settings.

Matched by original PDF filename

Storage
Review the source for packaging, storage and opened-package instructions.
Drying
Candidate injection-molding recommendations: processing moisture ≤0.1 %. Verify the source, grade and conditions.
Equipment setup
Candidate injection-molding recommendations: melt temperature 250 - 310 °C; mold temperature 80 - 140 °C. Verify the source, grade and conditions.
Applications
Candidate application areas in the source: electrical and electronics. Verify the source, exact use and applicable approvals.

Source: the matched material PDF; page numbers refer to the original PDF.

  • Processing moisture:page 1
  • Melt temperature:page 1
  • Mold temperature:page 1
  • Application areas:page 1